CFD INVESTIGATION OF TURBULENT WATER FLOW IN A PIPE ELBOW: ASSESSMENT OF CAVITATION RISK

Proceedings of 41st Danubia-Adria Symposium Advances in Experimental Mechanics (pp. 159-162)

 

АУТОР(И) / AUTHOR(S): Pavle Ljubojević , Saša Stašević

Download Full Pdf 

DOI:  10.46793/41DAS2025.159LJ

УВОД / INTRODUCTION:

Cavitation represents the formation and subsequent collapse of vapor or gas bubbles in the vicinity of solid surfaces. Depending on the mechanism of initiation, cavitation can be classified as hydrodynamic, acoustic, optical, or particle cavitation. Broadly, these phenomena may be grouped into two categories: cavitation induced by stress in liquids (hydrodynamic and acoustic) and cavitation induced by localised energy deposition (optical and particle).

In mechanical systems, particularly in fluid transport applications, hydrodynamic cavitation is the most common type and is associated with adverse effects such as noise, vibration, and a reduction in the load-carrying capacity and durability of machine elements (gears and bearings). A combined mechanism, referred to as hydrodynamic–acoustic cavitation (HAC), arises when structural vibrations at specific natural frequencies, or other excitation sources, produce pressure fluctuations that promote bubble formation under the influence of ultrasound. In such cases, acoustic cavitation act synergistically with hydrodynamic cavitation, resulting in more severe material degradation within the system. Both hydrodynamic and acoustic cavitation processes generally progress through four characteristic stages: incubation, acceleration, deceleration, and terminal stage. Potentially, a fifth phase may also appear, which refers to the complete degradation of the work and the consequences of which can be catastrophic.

In fluid transport piping systems, cavitation arises in regions where the local pressure decreases below the saturation pressure. Such conditions may occur along straight pipe sections due to frictional losses, at abrupt changes in flow direction (e.g., elbows), within various fittings, or in pump impellers. In addition, entrained gas molecules within the liquid often act as nucleation sites for vapour–gas bubble formation, thereby promoting the initiation of cavitation [8–10]. Therefore, one of the key parameters when sizing and determining the geometry of pipelines is protection against cavitation.

In this study, computational fluid dynamics (CFD) simulations using OpenFOAM were conducted to investigate water flow through a DN65 pipe elbow at five different average inlet velocities: 5, 10, 15, 20, and 25 m/s. Although such elbows are not typically subjected to these flow rates in practical applications, the primary objective of this research was to identify the threshold average inlet velocity at which the system pressure falls below the saturation pressure.

КЉУЧНЕ РЕЧИ / KEYWORDS:

ПРОЈЕКАТ / ACKNOWLEDGEMENT:

This work was supported by the Ministry of Science, Technological Development and
Innovations of the Republic of Serbia (Contracts: 451-03-137/2025-03/ 200105) and CA23155 – A pan-European network of Ocean Tribology (OTC).

ЛИТЕРАТУРА / REFERENCES:

  • Knapp, R.T. Cavitation Mechanics and its Relation to the Design of Hydraulic Equipment. Proceedings of the Institution of Mechanical Engineers, 1992 166, 150–163.

  • Dojčinović, M. Razaranje materijala pod dejstvom kavitacije; Monograph, Tehnološko-metalurški fakultet, Beograd, 2013.

  • Lauterborn, W. Cavitation and Inhomogeneities in Underwater Acoustics. In Proceedings of the First International Conference, Göttingen, Fed. Rep. of Germany, July 9–11, 1979; Springer Science & Business Media (2012)

  • Dowson, D., Taylor, C.M. Cavitation in Bearings. Annu. Rev. Fluid Mech., 1979, 11, 35–65. https://doi.org/10.1146/annurev.fl.11.010179.000 343

  • Ouyang, T., Mo, X., Lu, Y., Wang, J. CFDvibration coupled model for predicting cavitation in gear transmissions. International Journal of Mechanical Sciences, 2022, 225.

  • Wu, P., Bai, L., Lin, W., Wang, X.: Mechanism and dynamics of hydrodynamic-acoustic cavitation (HAC). Ultrasonics Sonochemistry, 2018, 49, 89–96.

  • G02 Committee: Test Method for Cavitation Erosion Using Vibratory Apparatus, http://www.astm.org/cgi-bin/resolver.cgi?G32-16

  • Chang, H., Xie, X., Zheng, Y., Shu, S., Numerical study on the cavitating flow in liquid hydrogen through elbow pipes with a simplified cavitation model. International Journal of Hydrogen Energy, 2017, 42, 18325–18332.

  • Jin, Z., Gao, Z., Qian, J., Wu, Z., Sunden, B., A Parametric Study of Hydrodynamic Cavitation Inside Globe Valves. Journal of Fluids Engineering, 2018, 140.

  • Martin, C.S., Medlarz, H., Wiggert, D.C., Brennen, C., Cavitation Inception in Spool Valves. Journal of Fluids Engineering, 1981, 103, 564– 575.

  • Homicz, G.: Computational Fluid Dynamic simulations of pipe elbow flow, (2004)

  • Genic, S., Aranđelović, I., Kolendić, P., Jarić, M., Budimir, N., Genić, V., A Review of Explicit Approximations of Colebrook’s Equation. FME Transaction, 2011, 39(2), 67-71.